LinkBack URL
About LinkBacksWhere should you start with mods for the 800 SXR for a race boat come surf machine
Where should you start with mods for the 800 SXR for a race boat come surf machine
in this order below.
remove rubber inlets from airbox.
scoop grate
rideplate
pole spring tensioner
bigger jets in carbs
handle bars
What size jets would you recomend?
Rubber gromets first thing to go.
Pole spring tensioner was second.
Scoop grate and sponsons and jetting are next...
Will keep stock ride plate a little longer...
Big Ass PIPE..................
JET SPORT WEST
www.jetsportwest.asn.au
(PERTH PWC CLUB)
the fastest limited in the country ( jamin townsends) had the fastest ignition systyem in the country in it
by adding a decent controlled amount of advance down low you can make the ski burst off the line
and then by using a programable ignition you can get rid of the timing to allow the top end to survive as well
Last edited by waxhead; 02-01-2007 at 04:54 AM.
Yes i agree with wax.
Get ignition if you dont go pipe first.
Jets i cannot remember sizes but i know it was 2 or 3 up size.
Ok done the timing advance... took 30 seconds to do...
Done the rideplate and scoop grate...
RD scoop[ and works concave rideplate
and homemade sponsons,..
The handling difference is unbelievable....
the difference the timing advance makes is also good bottom end
Just to rejet and do some zero degree bars....
Get onto Hosko on ozpwc. He has a stockie. He has benefited from others with what jets to use. I am sure he will let ya know.
Thanks Mooka,] will do...
Be careful now if you decide to try a exhaust cone for your ski
You have a bag of advance in the midrange now and it will create alot of engine heat
Posting Permissions
Reply With Quote