Seadoo 4.TecTruble codes!
+ Reply to Thread
Page 1 of 2 1 2 LastLast
Results 1 to 10 of 12

Thread: Seadoo 4.TecTruble codes!

  1. 21-12-2006 04:43 AM #1
    JetZone
    JetZone is offline
    Member
    Join Date
    Nov 2006
    Location
    Copenhagen Denmark
    Posts
    30

    Seadoo 4.TecTruble codes!

    Hi guys hope this can help.
    found them on another forum!

    Here is the list of trouble codes displayed on all Sea-Doo 4-stroke 4-TEC equiped skis. It will take a dealer and parts to cure most of these, but it at least gives you an indication of the fault, and sometimes you can replace the part yourself.

    P0106
    Manifold atmospheric presure sensor out of range

    P0107
    Manifold atmospheric presure sensor or Manifold barometric presure sensor shorted to ground

    P0108
    Manifold atmospheric presure sensor or Manifold barometric presure sensor shorted to 12V or open circuit

    P0111
    Intake manifold temp sensor faulty

    P0112
    Intake manifold shorted to ground

    P0113
    Intake manifold shorted to 12V or open circuit

    P0116
    Engine temp sensor faulty

    P0117
    Engine temp sensor shorted to ground

    P0118
    Engine temp sensor shorted to 12V or open circuit

    P0122
    TPS out of range - short to ground

    P0123
    TPS out of range - short to 12V or open circuit

    P01231
    Fuel pump shorted to ground or open circuit

    P0232
    Fuel pump shorted to 12V

    P0261
    #1 injector short to ground or open circuit

    P0262
    #1 injector shorted to 12V

    P0264
    #2 injector short to ground or open circuit

    P0265
    #2 injector shorted to 12V

    P0267
    #3 injector short to ground or open circuit

    P0268
    #3 injector shorted to 12V

    P0236
    Knock sensor out of range

    P0336
    Crank position sensor - wrong RPM detected

    P0337
    No CPS signal, but CAPS signal detected

    P0339
    Crank signal fault not plausible with cam signal

    P0344
    Cam phase sensor signal missing

    P0351
    Ignition coil #1 open circuit or shorted to ground or to 12V

    P0352
    Ignition coil #2 open circuit or shorted to ground or to 12V


    P0353
    Ignition coil #3 open circuit or shorted to ground or to 12V

    P0461
    Fuel level sensor circuit out of range

    P0462
    Fuel level sensor shorted to ground

    P0463
    Fuel level sensor circuit shorted to 12V or open circuit

    P0505
    DLA output stage cutoff memory cuircut or output stage fault or open circuit or short to 12V

    P0513
    Incorrect DESS key

    P0520
    Oil pressure switch faulty

    P0544
    Exhaust gas temperature sensor fautly

    P0545
    Exhaust gas temperature switch shorted to ground

    P0546
    Exhaust gas temperature switch shorted to 12V or open circuit

    P0562
    Battery voltage too low

    P0536
    Battery voltage too high

    P0600
    CAN communication problem detected by EMS or MPEM

    P0601
    TPS learns unlikely or checksum fault

    P0602
    ECU not coded

    P0604
    RAM faulty

    P0605
    EEPROM faulty

    P0605
    Checksum fault EEPROM

    P0608
    Sensor 5V power supply short to ground

    P0608
    Sensor 5V power supply short to 12V

    P0616
    Starter relay short to ground or open circuit

    P0617
    Starter relay short to 12V

    P1102
    TPS adaption failure

    P1104
    TPS adaption cancelled

    P1148
    Fuel injector 1,2 or 3 - safety fuel cutoff disabled

    P1200
    Blow-by valve shorted to ground or open circuit

    P1201
    Blow-by valve shorted to 12V

    P1202
    Oil tank pressure switch implausible or blow-by valve still closed

    P1517
    Compass out of range

    P1590
    VTS position sensor out of range

    P1591
    VTS position sensor - low voltage

    P1592
    VTS position sensor - high voltage

    P1593
    VTS malfunction

    P1607
    MPEM fault

    P1675
    Spare output 1 shorted to ground or open circuit

    P1676
    Spare output 1 shorted to 12V

    P1678
    Spare output 2 shorted to ground or open circuit

    P1679
    Spare output 2 shorted to 12V

    P1680
    Comminication problem detected by MPEM

    P1681
    Communication problem - instrument cluster message missing

    P1682
    Communication problem - EMS message missing

    P1683
    COM RAM fault

    P1690
    VTS control up circuit open circuit or shorted to ground

    P1691
    VTS control up circuit shorted to battery

    P1692
    VTS control down circuit open circuit or shorted to ground

    P1693
    VTS control down circuit shorted to battery

    P0344, P1200
    Burnt TOPS 10A fuse

    P1675
    Burnt depth gauge or spare 2A fuse

    P0353, P0267
    Burnt cylinder #3 ignition coil and injection 10A fuse

    P0352, P0264
    Burnt cylinder #2 ignition coil and injection 10A fuse

    P0351, P0261
    Burnt cylinder #1 ignition coil and injection 10A fuse

    P1680, P1681
    Burnt information center 1A fuse

    P0616
    Burnt Bilge pump, beeper, diagnostic center 3A fuse

    P1678
    Burnt spare 5A fuse

    P0231
    Burnt starter, fuel pump 10A fuse

    P0600
    Burnt MPEM 2A fuse

    P1690, P1692

    Burnt VTS 7.5A fuse
    Zapata Hull /UMI/ mod RivaR sponsons.
    JetZone Engine: CP-Pistons/Carillo-Rodkit/light ball. shaft/RR t-wheel/ GH blockguard/JetZone Open lupe/ RR oiljet./RR eng-mont/
    SC 9100 ECU/ RE fuel reg./ Walbro pump.
    SC C-supercharger "R" 22psi mod/spec 100mm inducerring.
    JetZone Head mod with RotaxR C-Cam, big JetZone valves/RivaR retainers. 60mm t-body.
    3" IC/
    JetZone 5>4" Filterkit
    3" J-pipe with landa/ 3"w-box/ 3"exhaust, 3,5" outlet
    Going for the 100mph+ club
    [SIGPIC]
    Reply With Quote Reply With Quote
  2. 21-12-2006 07:54 AM #2
    US PERFORMANCE PRODUCTS
    US PERFORMANCE PRODUCTS is offline
    Senior Member US PERFORMANCE PRODUCTS's Avatar
    Join Date
    Nov 2006
    Location
    PERTH
    Posts
    292
    Send a message via Skype™ to US PERFORMANCE PRODUCTS
    Great post JETZONE!
    1 TUFF RXP
    Reply With Quote Reply With Quote
  3. 11-01-2007 11:33 AM #3
    cadtaz
    cadtaz is offline
    Member
    Join Date
    Jan 2007
    Location
    Perth WA
    Posts
    55

    Wow No Doubt Great Post

    I will copy and print this out Laminate and poster my garrage wall oh hell carry a copy in the ski 8K's off shore and get a warning i know to cut wires or quit riding for the day.

    Hmmmmmm or sink ski get on Jasons ski for a ride back and collect insurance


    I noticed there was not a CODE for "too much AIRFLOW under the ski "

    Wave Jumpers Anonymous

    Jason we will have to start a Rehab

    WJA " Hi i'm Mick and I have a problem " " AIR! " twitch twitch

    Dude!
    Reply With Quote Reply With Quote
  4. 04-02-2007 04:43 PM #4
    Dlinkwint
    Dlinkwint is offline
    Senior Member Dlinkwint's Avatar
    Join Date
    Nov 2006
    Location
    Perth
    Posts
    475
    no code for cracked oil cooler!
    Reply With Quote Reply With Quote
  5. 04-02-2007 05:24 PM #5
    chookc
    chookc is offline
    Senior Member chookc's Avatar
    Join Date
    Nov 2006
    Location
    Perth WA
    Posts
    1,543
    Did we find the problem?
    JET SPORT WEST
    www.jetsportwest.asn.au
    Reply With Quote Reply With Quote
  6. 04-02-2007 05:45 PM #6
    Dlinkwint
    Dlinkwint is offline
    Senior Member Dlinkwint's Avatar
    Join Date
    Nov 2006
    Location
    Perth
    Posts
    475
    Bryan suspects a crack in the oil cooler. Glad he finally found it. I think he was getting annoyed of me nagging him all the time
    Reply With Quote Reply With Quote
  7. 04-02-2007 08:55 PM #7
    waxhead
    waxhead is offline
    Member
    Join Date
    Nov 2006
    Posts
    55
    Now thats good info i am going to be laminating that myself

    A section that has the codes , wiring diagrams or other stuff like that for skis may be a good addition to the site

    I am happy to provide some information for that section as well
    sorry for the post hijack
    Reply With Quote Reply With Quote
  8. 04-02-2007 10:14 PM #8
    US PERFORMANCE PRODUCTS
    US PERFORMANCE PRODUCTS is offline
    Senior Member US PERFORMANCE PRODUCTS's Avatar
    Join Date
    Nov 2006
    Location
    PERTH
    Posts
    292
    Send a message via Skype™ to US PERFORMANCE PRODUCTS
    Hi Waxhead,

    Any good information is welcome especially if it can benefit others....
    1 TUFF RXP
    Reply With Quote Reply With Quote
  9. 04-02-2007 10:40 PM #9
    waxhead
    waxhead is offline
    Member
    Join Date
    Nov 2006
    Posts
    55
    Well i have plenty of yamaha stuff to help if i can
    Reply With Quote Reply With Quote
  10. 09-03-2009 10:58 AM #10
    mrayner
    mrayner is offline
    Member
    Join Date
    Mar 2009
    Posts
    4
    hey,
    i have a 2007 seadoo 4 tec series with a fault code of P0544 can i fix this myself or does it have to go to the dealer and what caused it to go faulty can you email me with the results please at calmfeathers@cablespeed.com thanks mark
    Reply With Quote Reply With Quote
+ Reply to Thread
Page 1 of 2 1 2 LastLast
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules